Illuminated pool with a wooden edge at sunset

Pool blog

Pools, Useful tips

Pool solar panels: how many you need and how to connect them

Pool solar panels: a solar panel on a stand next to the pool, connected to the sand filter

Short answer: the size and number of pool solar panels depend on the water volume. The manufacturer Mountfield recommends a 3.6 m² panel for pools up to 20 – 25 m³ and a 5.4 m² panel for pools from 30 to 45 m³. For an above-ground pool up to 15 m³ there is the Slim panel of 1.8 m². Properly fitted, a panel raises the water temperature by up to 6 °C in summer compared with an unheated pool. You connect the panels to the filter outlet, and you stop them when the water is above 30 °C. Below you will see which panel suits each pool, how solar heating works and how to fit it.

Pool solar panels: a solar panel on a stand next to the pool, connected to the sand filter
An example of a solar panel fitted next to a pool.

How many solar panels does your pool need

The number and size depend on the pool volume. If the panel is smaller than recommended, the result will not be satisfactory. In addition, in colder mountain areas the manufacturer advises a larger surface. You can connect the panels to each other, and all the models are in the solar heating category.

Pool volumePanelDimensionsPrice from
up to 15 m³, above-ground poolSlim 1.8 m²0.60 × 3.00 m106.83 €
up to 20 – 25 m³3.6 m² panel3.00 × 1.20 m174.40 €
from 30 to 45 m³5.4 m² panel4.50 × 1.20 m247.50 €

Prices as of 18/11/2026, subject to change. If your volume falls between two limits, choose the larger panel. For pools above 45 m³ the manufacturer gives no number of panels, so write to us. The LUX 800 collector of 0.8 m² is for pools above 10 m³ and you combine it with more panels of the same type. According to the manufacturer, it has up to 46 % more efficiency, and it costs from 149 €. To weigh up the different ways of heating the water, read the article on how to extend the swimming season.

Does a solar pool heater work

Yes, it works, as long as the pool has a pump with a sand filter. The panel is made of solid polypropylene and does not hold limescale. The filter pump pushes the cold pool water through the narrow channels of the panel. There the sun heats it and it returns to the pool. So you use solar energy for free.

In cloudy or rainy weather, the panel works less well. However, after 1 or 2 sunny days the water temperature rises again. Therefore the panel performs best together with a solar cover, which keeps the heat in at night. See the article on the solar pool cover.

How many degrees do pool solar panels add

Properly fitted, the panel raises the temperature by up to 6 °C in summer compared with an unheated pool. The water must not exceed 30 °C. Water that is too warm does not refresh, favours algae and can stretch the liner, and the pump can overheat. So stop the panel when the water reaches 30 °C.

If you want warm water that does not depend on the sun, there are also heat pumps. How to choose their power is explained in the article on heat pump power.

How to fit solar panels on a pool

  1. Choose a spot with at least 6 hours of direct sun a day.
  2. On a sloping surface, face the panel south or south-west. The best angle from May to September is 30 – 45 degrees.
  3. Place the panel at least 1.5 m from the pool, so it does not make it easier for children and pets to reach the water.
  4. Fix it firmly to a special stand or to a sloping surface, for example a roof, so the wind cannot carry it off.
  5. Connect it to the filter outlet. There must be no valves or filter tanks between the panel and the return nozzle.
  6. Choose a hose of the length you need.

Do not fit the panel near PVC-U drainage pipes, where the temperature can reach 70 °C. In addition, if the panel goes further from the pool or above the water level, consult a specialist. To check the flow, put your hand on the panel: if the surface is cold, enough cold water is passing through.

Which parts you need besides the panel

PartWhat it is forPrice from
Aluminium stand for the 3.6 m² panelground mounting110.80 €
Aluminium stand for the 5.4 m² panelground mounting199.70 €
Monobloc valve d32/38adjusts or stops the flow through the panel21.40 €
Corrugated hose d32connecting the panels2.90 € per 1 m
Hose d38connecting the panels3.40 € per 1 m

A solar panel only heats while the sun shines on it. At night it is usually colder and the panel would cool the water. So the manual bypass stops it, for example during night filtration. The panels of 3.6 m² with valve and of 5.4 m² with valve include it and cost from 195.80 € and from 269 €. The panels have connectors for 32/38 mm hoses, and you buy the hose separately in the length you need.

Frequently asked questions about pool solar panels

How many solar panels do I need for my pool?

It depends on the volume: for 20 – 25 m³, a 3.6 m² panel; for 30 – 45 m³, a 5.4 m² panel; for an above-ground pool up to 15 m³, the Slim panel of 1.8 m².

Does a solar pool heater work?

Yes, if the pool has a pump with a sand filter. The water passes through the panel, the sun heats it and it returns to the pool.

How do you fit the panels?

In a spot with at least 6 hours of sun, at least 1.5 m from the pool, firmly fixed and connected to the filter outlet.

How many degrees does the water gain?

Up to 6 °C in summer compared with an unheated pool. The water must not exceed 30 °C.

Can you connect several panels?

Yes, you connect the panels to each other with corrugated hoses. The whole range is in our Acuático pool shop.